Sliding glass doors
Single hung
Double hung
Horizontal roller
Casement
Bay & bow
Entry doors
Impact garage doors
PGT
CGIFree in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Get your free estimateStyles & brands we work with
- Single hung
- Double hung
- Horizontal roller
- Casement
- Bay & bow
- Sliding glass doors
- Entry doors
- Impact garage doors
- PGT
- CGI
See the difference
Before
After
Before
After
Before
AfterReplacement Doors in Henderson, NV
Replacement doors in Henderson means removing a failing or outdated exterior or interior door and fitting a new one into the existing opening – frame, hardware, seal, and finish included. Most homeowners call us when a door has stopped closing flush, when daylight shows through a corner, or when the original builder-grade unit has finally outlived its hardware. We handle it as a craft job rather than a swap: measure every opening twice, quote manufacturer lines side by side on paper, and register both warranty layers in writing before we leave. That is the standard our parent service, Door Installation, is built on, and it carries straight through to replacements. If you’re in Green Valley or Anthem and a door has started to fight you every summer, call (833) 842-6670 and a live person will pick up, day or night.
Henderson homes take a particular beating. The desert sun bakes west- and south-facing doors for eight or nine hours a day, and the temperature swing from a 110-degree afternoon to a 75-degree night works the frame, the seal, and the finish year after year. A door that was fine in 2005 often is not fine now, and the failure usually shows up at the edges first.
Key Takeaways
- Replacement doors in Henderson typically run $650 to $4,200 installed, depending on material, size, and whether the frame stays.
- Most replacements are done in a single visit, with warranty registration handled before we leave.
- Our technicians have up to 18 years of experience, and every job is covered by the 90-Day Done Right Promise.
- We’re an authorized installer for more than a dozen manufacturer lines, including PGT, CGI, and ES Windows.
When You Need Replacement Doors
Doors rarely fail all at once. They give you hints for a couple of seasons first, and most of the homeowners we talk to have been living with one or two of these for longer than they’d like to admit.
- The door binds in July and swings free in January. In Henderson, this almost always points to a frame that has moved with the heat, or a slab that has swollen past what the hinges can carry. If you have to shoulder the door open in summer, the opening itself needs a look, not just new hinges.
- Daylight or a draft at the corners. A visible gap at the top or strike side means the weatherstripping has flattened or the door has warped out of square. In our climate that gap also lets in fine dust from the desert, which you’ll find as a grit line on the threshold.
- Water staining or soft wood at the base. Slab doors on older Henderson homes often wick moisture at the bottom rail, especially on north-facing entries that stay shaded. Once the wood goes soft, patching is a short-term answer.
- Fogged or cracked glass in a patio or French door. A sealed unit that has lost its gas shows a milky haze between the panes. The door still works, but the glass has to be replaced, and on older units it’s often smarter to replace the whole door than chase a matching pane.
- Hardware that no longer matches anything made. Builder-grade locksets and multi-point patio hardware from fifteen or twenty years ago are increasingly hard to source. When a part fails and no replacement exists, the door is effectively at the end of its road.
- You’re staying put and want it right. Plenty of our customers aren’t fixing a failure at all. They’ve decided this is the house, and they want an entry door that closes with one hand and looks like it belongs.
If any of that sounds familiar, it’s worth a free estimate before a small problem turns into a frame repair. We’d rather look at a door that’s merely tired than one that’s already let water in.
Our Replacement Doors Process
We keep the process plain so you know exactly what happens and when. No surprise line items, no second appointment left hanging.
- Measure every opening twice. Our technicians measure the rough opening, the slab, and the reveal on both sides. Doors are not standard once a house has settled, and a measurement taken once is a measurement you’ll regret. This is the step that decides whether the existing frame stays or comes out.
- Quote manufacturer lines side by side on paper. You’ll see what each option costs and what it includes, in writing. If PGT makes sense for a patio door and a composite entry from another line fits your budget better, you’ll see both on the same sheet and decide with the numbers in front of you.
- Confirm the details before ordering. Swing direction, hardware finish, threshold height, and whether trim needs to be replaced – all settled up front. Custom sizes and special-order finishes add lead time, and we’ll tell you the honest timeline rather than promise a date we can’t hold.
- Remove and set the new door on the day. The old unit comes out, the opening gets checked and prepped, and the new door is set, shimmed, and fastened square. Most replacements are completed in a single visit.
- Seal, finish, and test. Weatherstripping, threshold seal, and trim go on, then the door gets opened and closed enough times to prove it latches clean and doesn’t rub. We check it the way you will, by hand, before we call it done.
- Register both warranty layers in writing. Under The Keystone Standard, we register both the manufacturer warranty and our workmanship coverage before we leave, with the durations written down. No paperwork fights later.
Every job is backed by the 90-Day Done Right Promise: if it isn’t right, we make it right. And a live person answers the phone around the clock, so if something needs attention after we’ve gone, you reach a human, not a recording.
Replacement Doors Pricing in Henderson
Replacement doors in Henderson generally cost between $650 and $4,200 installed. The low end covers a standard interior or basic exterior slab in an existing frame; the high end covers a large impact-rated patio door or a custom entry with new trim and hardware. These are honest ranges, not teaser numbers – your free estimate will pin down the exact figure for your opening.
| What you’re replacing | Typical installed range |
|---|---|
| Interior door (standard slab, existing frame) | $650 – $1,100 |
| Exterior entry door, existing frame | $1,200 – $2,400 |
| Exterior entry door with new frame and trim | $1,900 – $3,200 |
| Sliding or patio door (standard) | $1,800 – $3,400 |
| Impact-rated patio or entry door | $2,600 – $4,200 |
| Custom or oversized door | Quoted per opening |
What affects the number
- Frame condition. If the existing frame is sound, the job is simpler. If it has swelled, rotted, or gone out of square, it comes out and the price reflects the extra work.
- Material and rating. A basic slab and a PGT impact unit are not the same product, and the price gap is real. We’ll show you both so you can weigh it.
- Size and customization. Oversized openings, sidelights, and non-standard widths move into custom territory.
- Hardware and finish. Locksets, handles, and decorative glass add cost, and you’ll see each line itemized.
We quote upfront, on paper, and the bill matches the quote. Standing offers include $50 off any repair over $250, an $89 seasonal tune-up, and a permanent 5% discount for seniors and veterans. Estimates are free – call (833) 842-6670 and we’ll set a time. If you’re also weighing window work at the same time, it’s worth reading our guidance on home window and door projects so the two jobs line up.
FAQs – Replacement Doors
How much does door replacement cost in Henderson?
Door replacement in Henderson typically ranges from about $650 for an interior slab to $4,200 for a large impact-rated or custom unit, installed. The biggest cost drivers are whether the frame stays, the material and rating of the door, and hardware. Call (833) 842-6670 for an exact quote – estimates are free.
Can you replace a door in a single visit?
Yes, most replacements are completed in a single visit when the door is in stock or arrives on schedule. Custom sizes and special-order finishes need lead time for delivery, and we’ll give you the honest timeline up front rather than a date we can’t hold. Call us and we’ll tell you what’s realistic for your door.
Should I repair or replace a failing door?
If the frame, slab, and seal are sound and only the hardware or weatherstripping has failed, repair usually makes sense. Once the slab is warped, the wood at the base is soft, or the glass unit has fogged, replacement is the better long-term spend. A technician can tell you which you’re looking at during a free estimate – just call (833) 842-6670.
Do you handle impact-rated doors for Henderson homes?
Yes, we install impact-rated doors from lines including PGT and ES Windows, which matter in a climate that sees high wind and heat. Impact rating also affects price and lead time, so it’s worth deciding early. Call (833) 842-6670 and we’ll walk you through the options side by side.
Henderson homeowners deserve a door that closes with one hand and stays that way season after season. Our technicians have up to 18 years of experience, we’re background-checked and uniformed, and we approach every job the way we’d approach work in our own mother’s house. From the first measurement to the warranty registration, nothing is left to guesswork. Call (833) 842-6670 for a free estimate on replacement doors in Henderson – a live person answers around the clock, and we’ll be there when we say.
Written by the team at TruePane Windows & Doors Henderson, serving Henderson.